The Apollo 13 disaster occurred right when the "oxygen tanks were stirred".

What does that mean?
What benefits does it give?
What would happen if they didn't stir the tanks?

  • 1
    $\begingroup$ In short: you stir oxygen to keep the cryogenic elements in the tanks from developing pockets where the temperature/density of the material varies. $\endgroup$
    – Mast
    Oct 9, 2019 at 9:42

2 Answers 2


There was no "slush" in the Apollo cryo tanks. The O2 and H2 in the tanks were stored at conditions that made them supercritical fluids. The critical pressure for O2 is ~ 730 psi, the Apollo tanks were at ~ 900 psi. (H2 critical pressure is ~187 psi).

enter image description here from Apollo Operations Handbook Block II Spacecraft , emphasis mine

These supercritical fluids tended to stratify in the free fall environment because of the heat input to the tanks by the heater assemblies. The fans were intended to mix up the supercritical fluids and keep the properties uniform throughout the tanks.

Stratification is the development of a temperature gradient and, therefore, a density gradient in a tank during heater operation. The fluid temperature is greatest near the heater surface, decreasing with distance from the heater. The corresponding density gradient proceeds from lowest density near the heater surface to higher density away from the heater. Since the heater surface is in close proximity to the quantity sensor, the development of stratification in a tank can often cause erroneous low readings by the quantity sensor because the fluid density in the vicinity is not representative (it is lower) of a homogenous tank density. The development of the stratified gradient may be so gradual that the error in quantity reading is not obvious, but it will be reflected in usage rates computed over relatively short time intervals. Dramatic decreases in quantity readings, on the order of 10 percent decrease in a few minutes, have been observed in H2 tanks on occasions. Such large quantity decreases may initially be interpreted as a tank leak. However, an actual quantity loss of such high rate would also be accompanied by an abnormal pressure decay. Tank stratification will not cause an abnormal pressure decay.

Quote from the Shuttle EGIL Console Handbook, from my personal notes.


  • $\begingroup$ But is the amount of available oxygen indicated by the pressure of mixed supercritical oxygen? What is the capacitance gauge be used for? $\endgroup$
    – Uwe
    Oct 7, 2019 at 19:25
  • 2
    $\begingroup$ The density of the oxygen is proportional to the mass in the tank, since the supercritical fluid fills the volume completely. That's what the probe measures. $\endgroup$ Oct 7, 2019 at 19:27
  • 1
    $\begingroup$ I asked a follow-up: space.stackexchange.com/questions/39232/… as I don't really understand fluid-dynamics or anything really about the storage of super-critical fluids in space. $\endgroup$ Oct 7, 2019 at 19:37
  • 1
    $\begingroup$ So the mass in the tank is measured by its density and the density is measured by the capacity of the gauge sensor. The dielectric constant of supercritical oxygen is proportional to its density. $\endgroup$
    – Uwe
    Oct 7, 2019 at 19:41
  • 2
    $\begingroup$ @RussellBorogove The quote in yellow in the answer is intended to answer that. It starts with "Stratification is the development of a temperature gradient... $\endgroup$ Oct 8, 2019 at 0:07

From this NASA pdf:

At 46:40:02 Mission Elapsed Time during the Apollo 13 mission, both oxygen tank fans were powered on, hopefully to get a more accurate reading of the tank pressure.

In fact, the pressure is not influenced by fan operation. The reading of the capacitance tank gauge depends on a uniform temperature of tank contents.

enter image description here

56 hours into the mission, at about 03:06 UT on 14 April 1970 (10:06 PM, April 13 EST), the power fans were turned on within the tank for the third "cryo-stir" of the mission, a procedure to stir the oxygen slush inside the tank which would tend to stratify. The exposed fan wires shorted and the teflon insulation caught fire in the pure oxygen environment. This fire rapidly heated and increased the pressure of the oxygen inside the tank, and may have spread along the wires to the electrical conduit in the side of the tank, which weakened and ruptured under the pressure, causing the no. 2 oxygen tank to explode. This damaged the no. 1 tank and parts of the interior of the service module and blew off the bay no. 4 cover.

Image and quote from this NASA page.

Through the first 46 hours of the mission, telemetered data and crew observations indicated that the performance of oxygen tank 2 was normal. At 046:40:02, the crew routinely turned on the fans in oxygen tank 2. Within three seconds, the oxygen tank 2 quantity indication changed from a normal reading of about 82 percent full to an obviously incorrect “off-scale high” reading of over 100 percent. Analysis of the electrical wiring of the quantity gauge revealed that this erroneous reading could have been caused by either a short circuit or an open circuit in the gauge wiring or a short circuit between the gauge plates. Subsequent events indicated that a short was the more likely failure mode.

At 047:54:50 and at 051:07:44, the oxygen tank 2 fans were turned on again, with no apparent adverse effects. The quantity gauge continued to read off-scale high.

From this NASA page.

So the fans were activated to mix the supercritical fluid oxygen to get a uniform temperature and uniform density for a better result from the capacitive filling level probe. Previous readings were above 100 %.

As Organic Marble mentioned, the tank stored neither gaseous nor liquid nor solid oxygen. The oxygen was in another state, the supercritical fluid.

  • 7
    $\begingroup$ Wow, I can't believe that document actually says slush. The O2 in those tanks was a supercritical fluid. $\endgroup$ Oct 7, 2019 at 19:10

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.